Can you put 3 subs on a mono amp?
No. It will be 12 Ohms. It would be 1.33(333333) ohms if they are in parallel.
Can you run 4 subs on a mono amp?
You can do this, but not sure how much you will get at 80 Watts per, but 4 of these in a car should give a good SPL level.
How many subs can you hook up to a mono amp?
two subs
This setup is perfect for a mono sub amp. By wiring the two subs in parallel (see the diagram) you’ll show a 2-ohm impedance to the amp. Mono amps are built for just this kind of situation, so you’ll get maximum power output from your amp investment. Check the diagram below for how to hook it up.
Is a monoblock amp better than a 2 channel?
Put simply; monoblock amplifiers can be used to amplify any single channel in an audio system. Only one monoblock amplifier is needed if there’s only one audio channel (a mono signal). If there are two channels, like in a stereo recording, we would need two monoblock amplifiers (or a stereo amplifier).
Can I run two subs on a mono amp?
A mono block amplifier has only 1 channel and cannot be bridged. The 2 outputs of a mono block amplifier are there to easily connect multiple subwoofers.
How do I hook up two subs to a mono amp?
By wiring the two subs in parallel (see the diagram) you’ll show a 2-ohm impedance to the amp. Mono amps are built for just this kind of situation, so you’ll get maximum power output from your amp investment. Check the diagram below for how to hook it up. Two 4-ohm SVC subs — a great place to use a mono amp. Wiring flexibility is the key here.
How many amps to power a 4-ohm subwoofer?
Jesus, You can power four DVC 4-ohm subs rated for 900 watts RMS each with a single amplifier that can put out up to 3600 watts RMS at 2 ohms, like a Rockford Fosgate T2500-1bdCP, or two amps that can each put out up to 1800 watts RMS at one ohm, like two Kicker CXA1800.1Ts.
Can I connect two 4-ohm subs together?
Greg, Two DVC 4-ohm subs can only get wired together to form a one-ohm load, a 4-ohm load, or a 16-ohm load. You know you can turn the volume down on a sub, if the amp makes it too loud and out of balance with the rest of the music.
Can I use a 2-channel amp for subs?
This is a great place to use a 2-channel amp. When you wire the subs as shown in the diagram below, the total impedance will be four ohms. A bridged 2-channel amp can provide plenty of power at a reasonable price. Get some good subs and a good amp and let it rip!