How do I troubleshoot my Frigidaire dishwasher?

How do I troubleshoot my Frigidaire dishwasher?

Troubleshooting a Broken Frigidaire Dishwasher

1. Check your circuit breaker and power connection to make sure the dishwasher is receiving power.
2. Make sure the water supply is on and providing adequate pressure.
3. Double-check your settings to make sure the delayed start and child lock features are inactivated.

Where is model number on Frigidaire dishwasher?

Your dishwasher’s model number may vary, but is most commonly found in one of two places. Either along the interior side of the door or along the right side of the tub of the dishwasher and is visible when the door is open.

How do you program a Frigidaire dishwasher?

Operating Instructions

1. Load Dishwasher (See Preparing and Loading Dishes).
2. Add detergent (See Dishwasher Dispenser & Detergents).
3. Add Rinse Aid, if needed (See Rinse Aid).
4. Run hot water faucet nearest dishwasher until water is hot.
5. Select desired CYCLE (See Cycle Chart).
6. Select desired OPTION (See Option Selections).

How do I reset my Frigidaire dishwasher?

Hold down the cancel button for at least 3 seconds. Find the cancel button on the far-right side of the control panel. To reset the dishwasher, hold this button down for 3 seconds or until the light display disappears or changes.

Why is my Frigidaire dishwasher blinking and not starting?

When the lights on a Frigidaire dishwasher are blinking, the first thing to do is perform a basic reset. To do this, simply unplug the dishwasher or flip off the circuit breaker and wait a few minutes before restoring power. Then restart the dishwasher and make a new wash selection.

How often should you clean your dishwasher filter?

According to house-maintenance expert Bob Vila, you should clean your dishwasher filter and drain once a month. Cleaning dishwashers isn’t difficult. Vila’s three-step process is easy to do and doesn’t require any special tools.

How do you reset a Frigidaire dishwasher?

Resetting the Dishwasher. Hold down the cancel button for at least 3 seconds. Find the cancel button on the far-right side of the control panel. To reset the dishwasher, hold this button down for 3 seconds or until the light display disappears or changes.

Why is my Frigidaire dishwasher lights blinking?

The heating element heats up the water to operating temperature. If the water doesn’t reach the proper temperature after a set amount of time, a light on the control panel might start flashing. To determine if the heating element has burned out, use a multimeter to test it for continuity.