How do you administer INFeD?
INFeD should be injected only into the muscle mass of the upper outer quadrant of the buttock -never into the arm or other exposed areas -and should be injected deeply, with a 2-inch or 3-inch 19 or 20 gauge needle.
How long does INFeD infusion take?
‘Patients are generally in the hospital for no more than a couple of hours,’ says Dr. Tan. The infusion itself takes around 15 minutes, and after the treatment, there is a period of observation before the patient is discharged.
How do you calculate dextran?
Iron Dextran Dosing Calculator (iron deficit)
- Dose (mL) = 0.0442 (Desired Hb – Observed Hb) x LBW + (0.26 x LBW)
- Desired Hb = the target Hb in g/dl.
- Observed Hb = the patient’s current hemoglobin in g/dl.
- LBW = Lean body weight in kg.
- Normal hemoglobin (males and females)
How often do you give INFeD?
Individual doses of 2 mL or less may be given on a daily basis until the calculated total amount required has been reached. INFeD is given undiluted at a slow gradual rate not to exceed 50 mg (1 mL) per minute.
What is the J code for INFeD?
J1750
Iron Dextran (INFeD) HCPCS code J1750: Billing Guidelines.
How long does it take for INFeD to work?
The onset is usually 24-48 hours after administration and symptoms generally subside within 3-4 days. The etiology of these reactions is not known. The potential for a delayed reaction must be considered when estimating the risk/benefit of treatment. The maximum daily dose should not exceed 2 mL undiluted iron dextran.
How many iron infusions do you need?
You may need one to three sessions of iron infusions, which are usually given about one week apart. The dosage and frequency of iron infusion will depend on which intravenous iron product your doctor prescribed and on the severity of your anemia.
How long does it take Infed to work?
How do you administer dextran IV?
The IV rate will carry some of the iron dextran to the patient within 2 to 5 minutes. This is effectively a “test dose.” If no change in vital signs occurs then gradually add additional iron dextran solution to the drip chamber over 10 to 15 minutes.
How long is an iron dextran infusion?
2.4 Test dose 25mg of CosmoFer® should be infused over a period of 15 minutes. The patient should then be observed for one hour. If no adverse reactions are seen, give the remaining dose. For subsequent doses the 25mg test dose must still be given, however there is no requirement for the one hour observation period.
How long does it take for Infed to work?
How fast do you infuse iron dextran?
25mg of CosmoFer® should be infused over a period of 15 minutes. The patient should then be observed for one hour. If no adverse reactions are seen, give the remaining dose. For subsequent doses the 25mg test dose must still be given, however there is no requirement for the one hour observation period.
What is the dosage for Infed?
INFeD is given undiluted at a slow gradual rate not to exceed 50 mg (1 mL) per minute. 2. Intramuscular Injection – PRIOR TO THE FIRST INTRAMUSCULAR INFeD THERAPEUTIC DOSE, ADMINISTER AN INTRAMUSCULAR TEST DOSE OF 0.5 ML. (See BOXED WARNING and PRECAUTIONS .)
How do you calculate the amount of Infed required for anemia?
Replacement Iron = 500 x 0.20 = 100 mg The total amount of INFeD required for the treatment of iron deficiency anemia or iron replacement for blood loss is determined from the table or appropriate formula. (See Dosage ). 1. Intravenous Injection – PRIOR TO THE FIRST INTRAVENOUS INFeD THERAPEUTIC DOSE, ADMINISTER AN INTRAVENOUS TEST DOSE OF 0.5 ML.
How do you administer Infed?
INFeD is given undiluted at a slow gradual rate not to exceed 50 mg (1 mL) per minute. 2. Intramuscular Injection – PRIOR TO RECEIVING THEIR FIRST INFeD THERAPEUTIC DOSE, ALL PATIENTS SHOULD BE GIVEN AN INTRAMUSCULAR TEST DOSE OF 0.5 mL. (See PRECAUTIONS: General.)
How do you calculate IV IV infusion rate?
IV Infusion Rate (cc/hr) = dose (mcg/kg/min) x weight (kg) x 60 min/hr concentration (mg/cc) x 1000 mcg/mg DISCLAIMER: All calculations must be confirmed before use.