How do you reset a White-Rodgers thermostat?

How do you reset a White-Rodgers thermostat?

Classic 80 & 70 Series White Rodgers Thermostat

1. Press and hold the Up and/or Down arrow and the TIME button at the same time.
2. The display will initially go blank and then reappear.
3. The configuration settings are now reset.

What is SS and HP on thermostat?

SS/HP Switch (Conventional or Heat Pump Selection) The SS/HP switch is factory set to the SS position. In this posi- tion, thermostat is configured as conventional single stage. If you have a single stage heat pump system, switch SS/HP to HP position (see figure 2).

What does system +2 mean on a thermostat?

1 “System On” indicates when heating or cooling stage is energized. “System On +2” indicates when a second stage is energized. 2 The word HOLD is displayed when the thermostat is in the HOLD mode. Temp HOLD is displayed when the thermostat is in a Temporary HOLD mode.

Can you replace a White-Rodgers thermostat?

The swap is easy to do because regardless of the increased functionality of the new thermostat, it will connect to the same wires as the old White-Rodgers thermostat and in the same way. That makes keeping track of the wires the most important part of the job of removing the old thermostat.

Where is the reset button on a thermostat?

How do I reset my thermostat?

1. Take the front of the thermostat off the wall and look for a small white round reset button on the right side labeled “H.W. Reset”.
2. Hold this button down for at least 5 seconds.
3. The screen should fully populate temporarily.

How do you reset a White-Rodgers thermostat after changing the battery?

Generally, you’ll need to open the thermostat cover and detach the wires from terminals R and C. Next, remove the batteries for a couple minutes and then replace them. Program your thermostat to the ambient temperature. If you hear one click, your thermostat has been reset.

What does R and W mean on thermostat?

W wire – heat. R wire – heat power. W wire – heat.

What is the L terminal on a thermostat?

L: This terminal is designated for indicator lights on the thermostat, sometimes for when auxiliary or emergency heat is turned on, or if there’s a general problem with your system.

What is better 1 stage or 2 stage furnace?

The ability to switch between two power modes makes two-stage furnaces more energy-efficient than their single-stage counterparts. The low power mode allows the unit to conserve energy as well as reduce temperature fluctuations and uneven heating in your home.

What is the difference between a single-stage and two-stage thermostat?

The difference between a one-stage and a two-stage furnace lies in their ability to control heat output. Single-stage heating requires only a fixed gas valve and a single-speed blower motor. This kind of furnace is either on or off. Two-stage heating requires a two-stage gas valve and a variable-speed blower motor.

Can you replace a White-Rodgers thermostat with Honeywell?

Take off the top of the White Rodgers thermostat. Remove and label each wire on the old subbase (bottom part screwed to wall) with the code on the terminal the wire comes out of. Mount the new Honeywell thermostat subbase. Connect the wires according to the labels on the Honeywell subbase.

Can I take old thermostat off wall?

So, all you need to do is switch off the mains power in the house, and remove the thermostat from its wires, and clamp each of them in a scotch-block terminal connector. Wear rubber gloves if you are nervous.