How much is a control board for fridge?

How much is a control board for fridge?

A compressor or control board may cost $80 for a budget refrigerator, but upwards of $800 for the high-end models.

How do I reprogram my Whirlpool refrigerator?

Programming Mode (Version 2):

  1. Press and hold the WATER Keypad.
  2. Press and hold LL Keypad.
  3. Release the WATER Keypad and wait 3 seconds.
  4. The control will display PE to indicate the programming mode.
  5. Entry is confirmed by pressing the LL Keypad once more.
  6. The control will display the current Program CODE.

Is there a reset button on my Whirlpool refrigerator?

Some Whirlpool refrigerators allow a soft reset. If your Whirlpool refrigerator is not functioning correctly, locate the door switches inside the refrigerator. Once you find them, press and release them. The fridge display will temporarily go blank and then kick back into normal operation.

How long do Whirlpool fridges last?

Depending on model and size, a properly maintained refrigerator can last between 14 and 17 years. A standard refrigerator can run up to 17 years on average, while a compact refrigerator can run for 14 years.

What is PCB refrigerator?

The printed circuit board (PCB) in your fridge is responsible for its electrical functions and settings. This means if your fridge is malfunctioning, the PCB could be to blame. This replacement PCB can be easily installed to restore functionality to your appliance.

How do you reprogram a refrigerator?

Here’s how to do it:

  1. Unplug your refrigerator. Disconnect your fridge from its power source by removing the power cord from the wall outlet.
  2. Turn off the refrigerator and freezer from the control panel.
  3. Reset your freezer and fridge temperature settings.
  4. Wait for the refrigerator temperature to stabilize.

How do you know if your refrigerator control board is bad?

Symptoms of a bad control board vary from cooling problems, erratic behavior, or the fridge not working at all. These control boards are in effect the same type of computer boards that are used in everyday computers and therefore susceptible to power outages, surges, spikes, and even to static electricity.

How do I Reset my Whirlpool refrigerator control panel?

Turn off the circuit breaker or unplug the fridge for 5-10 minutes.

  • Power the fridge by turning on the circuit breaker or plugging the fridge back in.
  • Turn on the cooling function.
  • Check the functionality of the control panel.
  • How to program Whirlpool refrigerator?

    Reset After Changing Water Filter. Whirlpool suggests that the water filter should be changed at least every six months to keep the water tasting fresh and clean.

  • Resetting the Control Panel.
  • Whirlpool Refrigerator Control Board Troubleshooting.
  • Does Whirlpool make the best refrigerators?

    – Always consider the “door-swing” in the refrigerator’s depth measurement. As the refrigerator door opens, it’ll extend 15 to 32 inches beyond the main compartment. – Don’t forget about space for the drawer. – Leave room for the hinge. – Leave some breathing room for ventilation.

    How do you fix a whirlpool refrigerator?

    Unplug the Fridge. Unplug the refrigerator from the electrical outlet.…

  • Remove Access Panel.…
  • Flush the Defrost Drain.…
  • Clear the Drain.…
  • Plug it Back In.