What is the MSDS number for acetone?
Material Safety Data Sheet (MSDS) – ACETONE Product Identification Synonyms: Dimethylketone; 2-propanone; dimethylketal CAS No.: 67-64-1 Molecular Weight: 58.08 Chemical Formula: (CH3)2CO
What is the OSHA limit for acetone?
Acetone: – OSHA Permissible Exposure Limit (PEL): 1000 ppm (TWA) -ACGIH Threshold Limit Value (TLV): 500 ppm (TWA), 750 ppm (STEL) A4 – not classifiable as a human carcinogen
Is acetone flammable?
When the acetone concentration is greater than 8% (by weight) in a closed container, it would be within flammable range and cause fire or explosion if a source of ignition were introduced. Fire Extinguishing Media Water spray, alcohol resistant foam, dry chemical or carbon dioxide.
What is the flash point of acetone?
Acetone/water solutions that contain more than 2.5% acetone have flash points. When the acetone concentration is greater than 8% (by weight) in a closed container, it would be within flammable range and cause fire or explosion if a source of ignition were introduced.
What are the synonyms of acetone?
Product code Formula Synonyms : Substance : Acetone : 2-Propanone : 67-64-1 : LC10420, LC10425 : C3H6O : 2-propanone / beta-ketopropane / dimethyl formaldehyde / dimethyl ketone / dimethylketal / DMK (=dimethyl ketone) / keto propane / methyl ketone / pyroacetic acid / pyroacetic ether / pyroacetic spirit
How long does it take for acetone to cure a weld?
Assemble supports to hold the joint together while the solvent evaporates from the weld. The curing time for a solvent weld is approximately three hours. Pour acetone into the two troughs. Make the level of the acetone between 3 and 5 mm. This will allow the bottom of the two pieces to soak.
How long does it take for a solvent weld to cure?
The curing time for a solvent weld is approximately three hours. Pour acetone into the two troughs. Make the level of the acetone between 3 and 5 mm. This will allow the bottom of the two pieces to soak.
How do you clean plexiglass with acetone?
Pour acetone into the two troughs. Make the level of the acetone between 3 and 5 mm. This will allow the bottom of the two pieces to soak. Allow the Plexiglass to soak for between 60 and 90 seconds. To determine the exact timing of the soak, perform this procedure using two scrap pieces of Plexiglass prior to welding the actual pieces of interest.