What size is a fan clutch wrench?

What size is a fan clutch wrench?

Removes Fan Clutch on Most Models. The turning wrench has the 5 common fan clutch nut sizes built into one tool: 7/8″ (22 mm), 1 7/16″ (36 mm), 1 9/16″ (39 mm), 1 7/8″ (47 mm) and 2″ (50 mm). Both wrenches are long to provide extra leverage for stubborn fan clutch nuts.

Why is my new fan clutch so loud?

A roaring noise could mean a number of things, including a bad wheel bearing, worn tires, or a differential that’s low on oil. Often times, it’s the fan clutch. When the clutch shoe inside the part gets stuck, it fails to disengage. When the fan is locked up, the cooling fan is permanently engaged.

How do you check a fan clutch?

To confirm the diagnosis, start with this simple test: Spin the fan as hard as you can on an engine that has not been started that day. If the fan rotates more than five times, you can bet the clutch is bad. You should feel some resistance and the fan may spin up to three times, depending on the ambient temperature.

What size is Ford fan clutch wrench?

40mm
4.9-L Ford Fan Clutch Wrench Wrench opening is 40mm (1.575″).

How does a primary clutch puller work?

The puller’s threads are farther back and a larger diameter, it threads into the clutch, and the longer unthreaded portion in front of it pushes up against the crank. As you tighten the puller, it pushes harder against the crank until the clutch pops free.

What is a starter clutch wrench?

$10.88. Starter clutch wrench. This wrench is to be used with a 7/8 inch socket to install, remove, or torque starter clutches both quickly and easily.

Is a clutch fan supposed to spin freely?

Expert Reply: If there is a fan clutch between the fan and radiator on your vehicle, then you will be able to turn the fan by hand when the engine is off and not running. If the fan is turning freely with no clutch, then there is a problem with either the belt being loose or the pulley will need adjustments.

How to remove fan clutch without tool?

Remove the Fan Clutch. Access the fan by getting the air intake hose, fan shroud, and the belt. Use the screwdriver to remove the intake hose. Once the screw loosens, remove the hose and shake until it fully moves out of its position. After getting the air intake hose, the fan shroud will be more accessible.

How do you remove the clutch fan?

Loosen the fan clutch-to-water pump hub retaining bolts.

  • If necessary,remove the drive belt from the water pump pulley.
  • Remove the fan shroud upper retaining screws.
  • Remove the fan clutch-to-water pump hub bolts and remove the fan and clutch assembly and the fan shroud.
  • How to remove clutch fan from water pump?

    Identify the Nut Size. Each fan clutch will have its own mounting nut size which will range from 22mm to 36mm depending on the application and manufacturer.

  • Hold the Water Pump Pulley. You must hold the water pump pulley in order to remove the fan clutch from the water pump.
  • Remove the Fan Clutch.
  • Replace the Fan Clutch.
  • Reinstall the Fan Clutch.
  • Can you change clutch without removing engine?

    there is no trick to doing a clutch without removing the trans. simply stand at the driver’s side fender and face the engine bay. now reach one hand and arm around either side of the transmission. How much to replace a clutch in a Camaro? The average cost for a Chevrolet Camaro clutch replacement is between $1,479 and $1,637.