What year is a 2210 John Deere?
John Deere 2210
| 2210 Serial Numbers | |
|---|---|
| Location: | Right side of main tractor frame, above the front axle. |
| 2003: | 2100001 |
| 2004: | 3100001 |
| 2005: | 4310001 |
Is a John Deere 2210 a 4 wheel drive?
John Deere 2210 tractor, 4×4, 563 hours, front loader, 3-point hitch, 540 pto, mid pto, 54″ deck, READY TO GO TO WORK!!!!!!!!
What category is a John Deere 2210?
The John Deere 2210 tractor has a category 1 three point hitch and its pto is claimed to produce 17.1 hp. This John Deere tractor has power steering and is offered in 4WD. View entire John Deere 2210 specifications below.
How wide is a John Deere 2210?
John Deere 2210 Dimensions
| Dimensions | |
|---|---|
| Wheelbase: | 57 inches 144 cm |
| Length: | 104 inches 264 cm |
| Width: | 47.9 inches 121 cm |
| Height (hood): | 41.8 inches 106 cm |
What oil does a John Deere 2210 take?
John Deere makes a full synthetic in the 0W-40 Plus 50 and so does Shell in 5W-40 as does many others. Use the oil that suits you BUT meets John Deere specs and use a GOOD quality oil filter. The Deere oil filter is made by Fleetguard and is about the best filter out there and cost less than $6.
What does a John Deere 2320 weigh?
John Deere 2320
| Dimensions & Tires | |
|---|---|
| Wheelbase: | 63 inches 160 cm |
| Weight: | 1660 lbs 752 kg |
| Front tire: | 23×8.5-12 |
| Rear tire: | 31×12-16.5 |
How many quarts of oil does a John Deere 2210 take?
John Deere 2210 Engine
| Engine Detail | |
|---|---|
| Yanmar 3TNE74 | |
| Starter volts: | 12 |
| Starter power: | 1.5 hp 1.1 kW |
| Oil capacity: | 2.1 qts 2.0 L |
How do you put hydraulic fluid in a John Deere tractor?
How to add hydraulic fluid on a John Deere tractor
- Wipe away any debris from the reservoir area.
- Remove hydraulic fluid reservoir cap (B) and add John Deere Hy-Gard Hydraulic and Transmission Oil using a clean funnel.
- Add a little fluid at a time to avoid overfilling the reservoir.
How much weight can a John Deere 2320 Lift?
John Deere 2320
| Tractor hitch | |
|---|---|
| Rear Type: | I |
| Control: | position control |
| Rear lift (at ends): | 1433 lbs 650 kg |
| Rear lift (at 24″/610mm): | 1150 lbs 521 kg |
What year did John Deere make the 2320?
John Deere 2320
| Model history | |
|---|---|
| Model introduced | 2006 |
| Model discontinued | Unknown |
| Model status | Unknown |
| Preceded by | John Deere 4110 |
What kind of oil does a John Deere 2210 take?
What kind of hydraulic fluid does John Deere take?
Hy-Gard
In the lab and in the field, Hy-Gard is preferred by John Deere engineers to deliver increased performance and protection of transmission and hydraulic systems. Hy-Gard retains proper viscosity over a wide range of operating temperatures thanks to its polymeric viscosity improver.