Where is the injector control pressure sensor located?
The ICP sensor is located on the driver side cylinder head towards the front of the engine near the high pressure oil pump. Remove the electrical connector from the ICP sensor by relieving the retaining clip and pulling upwards away from the sensor.
What is the ICP sensor on a 6.0 Powerstroke?
The ICP (Injection Control Pressure) Sensor is responsible for detecting the pressure of the oil feeding the injectors in the Ford 6.0 Powerstroke. A faulty ICP Sensor can cause all kinds of problems. Poor idle, stalling, surging, or not even allowing the engine to start at all.
Can you clean ICP sensor?
Yes, the ICP sensor is on the head, no real special tools needed, But If your refering to oil on the the IPR plug, it and the inside can get oily, if it’s giving you problems it can be cleaned, and maybe work great again.
Does an ICP sensor cause no start?
Injector Control Pressure Sensor: When an ICP is failing, the engine runs extremely rough as load is imposed (under throttle), and the condition can eventually contribute to a 7.3L’s inability to start. If the engine runs smoothly with the connector unplugged, the ICP is bad.
Can you drive with ICP sensor unplugged?
Unplugging the connector can cause the engine to run smoothly, but it can also cause the ICP to fail.
Where is the ICP sensor on a 2003 6.0 Powerstroke?
On 2003 and early 2004 model year 6.0L Power Stroke engines, the ICP sensor is located behind the turbocharger and beneath the turbocharger up-pipe collector (turbine inlet), fastened through the high pressure oil pump (HPOP) cover next to the IPR valve.
What is an ICP sensor?
An injection control pressure sensor, or an ICP sensor, is part of the engine. The sensor provides information about the pressure to provide the vehicle with appropriate feedback on the appropriate amount of fuel delivery based on the current driving conditions.
What happens if you unplug your ICP sensor?
An ICP sensor that fails can cause the engine to run extremely rough when load is applied (under throttle), and the condition can eventually lead to a 7 or higher engine performance. Unplugging the connector can cause the engine to run smoothly, but it can also cause the ICP to fail.
Where is the IPR sensor on a 6.0 Powerstroke?
The IPR valve is located in the output circuit of the high pressure oil pump (HPOP).
What does a ICP sensor do?
The injector control pressure (ICP) sensor is on both the 7.3L and 6.0L Powerstroke engines. They use a high pressure oil system as a way to pressurize fuel in the injector body. Basically, the 7.3 Power Stroke ICP, IPR, and HPOP provide enough oil pressure to the rails to ensure the 7.3 injectors actuate.