Why does my Onkyo receiver keep shutting off?
When you connect the bad wire or speaker the receiver will shut down. If after you connect them all if the receiver now stays on then there was a short where the wires were connected to the receiver that you repaired when you replaced them.
Why is my Onkyo receiver going in protect mode?
The Onkyo protection circuit is activated when the sensor in the receiver detects excessive heat or voltage irregularities. Using speakers with the incorrect impedance and running the receiver at excessive volumes for a prolonged period will trigger the protection circuit.
How do you troubleshoot an Onkyo receiver?
Reset the Onkyo if you continue to have trouble. Hold the “VCR/DVD” button while pressing the “On/Standby” button, and the receiver should enter “Standby.” Turn it on again by pressing the “On/Standby” button.
Why does my receiver keep shutting off?
In many cases, premature shutoff of your unit can be caused by a problem with the speaker wiring between the receiver and speakers. A single strand of wire in the wrong place (causing a short circuit condition) will cause the unit to shut off at anything but very low volume levels.
Why does my amplifier keeps turning off?
There are several different reasons that an amplifier will get hot and shut down. Four of the most common are: Blown/grounded speaker(s), poor power and/or ground connections, too low an impedance (load), or Gain/Punch Bass control settings too high.
What is standby hybrid?
Hybrid sleep is a type of sleep state that combines sleep and hibernate. Desktop computers typically don’t have a backup battery, so a loss of power means instant loss of sleep state.
How do I reset my Onkyo HT r693?
Press and hold down 2HOME until the 3 remote indicator lights (about 3 seconds). Within 30 seconds, press 1RCV again.
Why does my stereo shut off when I turn it up?
If the car stereo or amplifier powers off when raising the volume, then there may be an issue with installation. This usually occurs when the ground wire is not connected properly. However, it also can occur when an amplifier becomes overloaded by connecting too many speakers.
How do I know if my receiver is bad?
Connect a different speaker to right front output. If you hear the static it’s the receiver. If you don’t it’s probably the speaker. You could also move the right front speaker to the left front output and see if you hear anything.