Will American Strat neck fit Mexican body?

Will American Strat neck fit Mexican body?

It will fit. The extra fret just hangs over the pickguard. The new 2015 deluxe strats have a different heel which would require some modification. Standard strat necks and/or ones from earlier years will fit just fine unless it’s a really old 3-bolt neck.

How wide is the neck on a Fender Stratocaster?

The neck width at the nut of a typical Strat is 1.650 inches (42mm).

What is the radius of a PRS neck?

10-11.5″

What is fretboard radius?

The fingerboard radius is the measure of the arc of the fingerboard across its width. You don’t have to look too closely at most electric guitar and bass fingerboards to see that few if any of them are truly flat; most of them have a slight convex curvature across their width.

What guitar neck is best for small hands?

Small hands: C or flat C shaped necks Generally the shallower the profile the better e.g. C or flat C, provided it is in combination with a thin fretboard. One of the challenges of playing guitar with small hands is the ability to span frets.

What is a wide fat guitar neck?

The Wide Fat neck has the same nut width as the Wide Thin neck, but it has a deeper profile. Because of its strength and longer “heel”, the Wide Fat neck produces warm tones with lots of sustain. The Wide Thin neck has a thinner profile front to back than the Wide Fat.

What is the radius of the MIM Strat?

The MIM Standard Strat, as far as I know, has always had a 9.5″ radius. Same for the Standard HSS and Standard Plus Top. The MIM Deluxe Players Strat has a 12″ radius.

What is the radius of a Fender Strat?

The Classic Player strat has 12″ radius. The MIM Standard Strat, as far as I know, has always had a 9.5″ radius. Same for the Standard HSS and Standard Plus Top. The MIM Deluxe Players Strat has a 12″ radius. Fender has specs for all current production models on their website. Older models, of course, may vary. Thanks!

Is $550 too much for a MIM Strat?

Too much if its a MIM Standard, maybe not if it’s one of the higher up MIM. The higher up ones usually have upgrades such as better pickups, electronics, hardware etc. but it depends on the model. Even the. Though $550 may be on the high side for even one of the higher MIM Strats.

What is the standard Fender fingerboard radius?

Most prevalent is the modern 9.5” radius (241mm), which was adopted in the 1980s and is now found on about two thirds of Fender electric instruments. The next most common fingerboard radius, 7.25” (184mm), is a vintage-era spec now used on just under a third of Fender electric instruments.